Oleksandr ShyshatskyiandClaude Fable 5 6bf7eef238 A TEMP= heat-up is put back on exit, like every other snapshot ...

FF_PA_CALIBRATE TEMP=245 heated the hotend for the sweep and then left
it sitting at 245 forever: _heat only ran M104 + TEMPERATURE_WAIT and
nothing restored the target. Now _heat snapshots the heater's previous
target (usually 0) and both FF_PA_CALIBRATE and FF_PA_PROBE put it back
in a finally, so the heater comes back down even when the run fails.

A heater the operator set by hand -- no TEMP= given -- stays theirs,
the same put-back-what-we-found rule as the rest of _guarded.

Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_016RLsVzXppRdXChrDCsMKkA

2026-09-01 17:24:12 +03:00

..

3rdparty

Merge PR #9: the chamber heater's fan follows the heater

2026-08-31 15:46:00 +03:00

anvil-core

A printer ships knowing where its updates come from

2026-09-01 14:09:34 +03:00

helixscreen

Replace opkg with apk, and sign the feed

2026-08-31 14:32:07 +03:00

klipper

A TEMP= heat-up is put back on exit, like every other snapshot

2026-09-01 17:24:12 +03:00

klipper-config

Merge pull request #13 from Klipper4FlashForge/worktree-pa-sweep-chute

2026-09-01 15:39:14 +03:00

moonraker

Replace opkg with apk, and sign the feed

2026-08-31 14:32:07 +03:00

timelapse

Replace opkg with apk, and sign the feed

2026-08-31 14:32:07 +03:00

lib.sh

Make the apk feed buildable by CI, and signable by a release

2026-08-31 15:15:29 +03:00