Satvik Mishra
6c8e313283
Several links pointed at heading anchors that no longer exist (renamed or moved sections), so they did not jump to the intended section. Update them to the current anchors, and use a relative path for the sample-pwm-tool.cfg link so it resolves like the other config links. Signed-off-by: Satvik Mishra <Satvikmishra.ipu146183@maims.ac.in>
1.9 KiB
Using PWM tools
This document describes how to setup a PWM-controlled laser or spindle
using pwm_tool and some macros.
How does it work?
With re-purposing the printhead's fan pwm output, you can control
lasers or spindles.
This is useful if you use switchable print heads, for example
the E3D toolchanger or a DIY solution.
Usually, cam-tools such as LaserWeb can be configured to use M3-M5
commands, which stand for spindle speed CW (M3 S[0-255]),
spindle speed CCW (M4 S[0-255]) and spindle stop (M5).
Warning: When driving a laser, keep all security precautions that you can think of! Diode lasers are usually inverted. This means, that when the MCU restarts, the laser will be fully on for the time it takes the MCU to start up again. For good measure, it is recommended to always wear appropriate laser-goggles of the right wavelength if the laser is powered; and to disconnect the laser when it is not needed. Also, you should configure a safety timeout, so that when your host or MCU encounters an error, the tool will stop.
For an example configuration, see config/sample-pwm-tool.cfg.
Commands
M3/M4 S<value> : Set PWM duty-cycle. Values between 0 and 255.
M5 : Stop PWM output to shutdown value.
Laserweb Configuration
If you use Laserweb, a working configuration would be:
GCODE START:
M5 ; Disable Laser
G21 ; Set units to mm
G90 ; Absolute positioning
G0 Z0 F7000 ; Set Non-Cutting speed
GCODE END:
M5 ; Disable Laser
G91 ; relative
G0 Z+20 F4000 ;
G90 ; absolute
GCODE HOMING:
M5 ; Disable Laser
G28 ; Home all axis
TOOL ON:
M3 $INTENSITY
TOOL OFF:
M5 ; Disable Laser
LASER INTENSITY:
S